Connections to the system – MCZ Club HYDRO 15 kW User Manual
Page 34

PELLET STOVES
Chapter 3
INSTALLATION AND USE MANUAL
page
34
Installation and assembly
Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
3.4.1.
Connections to the system
Make the connections to the corresponding fittings shown in the
diagram on the previous page. Make sure the pipes are not placed
under tension or undersized.
IMPORTANT
IT IS STRONGLY RECOMMENDED TO FLUSH THE
ENTIRE SYSTEM BEFORE CONNECTING IT IN ORDER
TO GET RID OF RESIDUES AND DEPOSITS.
Upstream from the stove, always install valves so as
to disconnect it from the plumbing system should it
be necessary to move it, or when it requires routine
and/or special maintenance.
Connect the stove using flexible hoses so that the
stove is not too strictly connected to the system, and
to allow slight movements.
The pressure discharge valve (C) is always connected
to a water drain pipe. The pipe must be adequate to
support the water's high temperature and pressure.
A = TAP
B = DOMESTIC SYSTEM
C = PRESSURE DISCHARGE
D = FLEXIBLE PIPES
Pressure discharge valve (3 bar)
- Club HYDRO 15 kW High Efficiency Club HYDRO 15 kW Ver.2009 cod. 7109007 Club HYDRO 22 kW Club HYDRO 22 kW High Efficiency Ego HYDRO Ego HYDRO High Efficieny Musa HYDRO 15 kW Musa HYDRO 15 kW Ver.2009 cod. 7109008 Musa HYDRO 15 kW High Efficiency Musa HYDRO 22 kW Musa HYDRO 22 kW High Efficiency Star HYDRO Star HYDRO High Efficieny Suite HYDRO 15 kW Suite HYDRO 15 kW High Efficiency Suite HYDRO 15 kW Ver. 2009 cod. 7109007 Suite HYDRO 22 kW Suite HYDRO 22 kW High Efficiency