MCZ Club HYDRO 15 kW - Manual (Page 29)

PELLET STOVES Chapter 3
INSTALLATION AND USE MANUAL page 29
Installation and assembly Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
3.3.3.
Assembly of the lower panel – Suite and Club Stoves
The stove is delivered with all the ceramics packed. Therefore, before
assembling the side tiles and the top, it is necessary to insert the lower
panel.
Proceed in the following way:
 Remove the micro-perforated sheet metal grill B on the right
side (handle side) on the upper part by removing the two
screws C.
 Remove the screw D on the sheet metal E in a way that the
profile A is no longer locked.
 At this point slightly lift the sheet metal E and remove the
profile A.
 To remove the profile A lift it (sliding it from the base) and tilt
it slightly in a way that the plugs inserted on the base come
out.
 Take the lower panel F and insert it from the right (handle
side) towards the left in a way that it enters exactly in the
housings
 Reinsert the profile A making the plugs enter the case, and
lift the sheet metal E in a way to realign the profile “A”. Work
in a way that the upper plugs of the profile “A” are inserted in
the housings of the sheet metal “E”.
 With the screw D close the sheet metal E that keeps profile A
locked (fig.8)
 Before refitting the grill B with the two screws C, also insert
the side tiles (See par.3.3.4)
A
B
C
C
D
E
A
F
Figure 8 – Installation of lower front panel