MCZ Club HYDRO 15 kW - Manual (Page 10)

PELLET STOVES Chapter 2
INSTALLATION AND USE MANUAL page 10
Theoretical notions for installation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
2.2. PRECAUTIONS FOR INSTALLATION
IMPORTANT!
Installation and assembly of the stove must be
carried out by qualified personnel.
The stove must be installed in a suitable position to allow the normal
operations of opening and ordinary maintenance.
The site must be:
 capable of providing the environmental conditions for operation
 equipped with power supply 230V 50 Hz
 capable of taking an adequate system for smoke discharge
 provided with external ventilation
 provided with an earth connection complying with CEI
The stove must be connected to a flue pipe or an internal or
external vertical duct conforming to EN 1856-1-2 to suit the
appliance and types of fuels to be burnt – refer to detailed
guidance in sections 2, 3 and 4 in ADJ (ONLY FOR UK).
The stove must be positioned in such a way that the electrical
plug is accessible.
IMPORTANT!
The stove must be connected to a flue pipe or a
vertical duct which can discharge the fumes at the
highest point of the building.
The fumes are however derived from the combustion
of wood products, and if they come into contact with
or close to walls, they can make dirty marks.
Also take care because the fumes are very hot but
almost invisible, and can cause burns on contact.
The holes for the passage of the smoke pipe and for
the intake of air from outside should be made before
positioning the stove unit.