MCZ Club HYDRO 15 kW - Manual (Page 25)

PELLET STOVES Chapter 3
INSTALLATION AND USE MANUAL page 25
Installation and assembly Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
SUITE and CLUB stoves
Open the packaging, remove the two brackets that lock the stove to the
pallet (one on the right and one on the left side-fig.5)
The stove body or unit must always be kept in a vertical position when
moved, and moved only using carts. Special care must be used to
protect the door and the glass from impacts that would damage them.
Moving the product must always be done with care. If possible, unpack
the stove in the area where it is going to be installed.
The materials which make up the packaging are not toxic or harmful, so
no special procedures for disposal by required.
Their storage, disposal or possible recycling are therefore the responsibility of
the final user, in compliance with current legislation on the subject.
Do not store the stove unit or its cladding without their packaging.
Position the stove without its cladding and connect it to the flue pipe.
Use the four adjustable feet (J) to get the stove correctly levelled so
that the smoke outlet (S) is lined up with the connecting pipe (H).
Once the operations for connection are complete, assemble the
cladding (ceramics or steel sides).
If the stove needs to be connected to a discharge pipe which goes
through the rear wall (to connect up with the flue), take the greatest
care to make sure that the joint is not stressed.
If the smoke outlet of the stove is forced or used
improperly to lift it or position it, the operation of the
stove can be damaged irreparably.
Figure 5 - Removing the packaging screws
(in figure Suite stove)