MCZ Club HYDRO 15 kW - Manual (Page 4)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 4
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
4. OPERATION
4.1. PRE-LIGHTING WARNINGS
Do not touch the stove during the first lighting, as it
is during this phase that the paint sets. If you touch
the paint, you may expose the steel surface.
If necessary, touch up the paint with the aerosol spray in the original
colour (see the section "Accessories for pellet stoves").
It is good practice to provide plenty of ventilation in
the room during the initial lighting, as the stove will
give off a small amount of smoke and smell of paint.
ATTENTION!
Please ensure the brazier is clear of ALL pellets and
ash build up following any failed ignitions. Failure to
clear out the brazier prior to resetting may result in
further failed ignitions or in certain conditions an
explosive ignition.
Do not stay near the stove, and as previously mentioned, ventilate the
room. The smoke and the smell of paint will vanish after about one
hour of operation. There are no health risks involved.
The stove will be subject to expansion and contraction during the
stages of lighting and cooling down, and may therefore make slight
creaking noises.
This phenomenon is absolutely normal, the structure being made of
sheet steel, and must not be considered a fault.
It is extremely important to be sure not to take the stove to full heat
straight away, but to bring it gradually up to temperature.
Do not demand full heating
performance straight away!
Try to get familiar with the commands given from the control panel.
ATTENTION!
If during operation or initial ignition you encounter
smoke spillage in to the room from the appliance or
the flue then please switch off the appliance, ventilate
the room and contact the installation / service
engineer immediately.