beautypg.com

MCZ Club HYDRO 15 kW User Manual

Page 35

background image

PELLET STOVES

Chapter 5

INSTALLATION AND USE MANUAL

page

35

Maintenance and cleaning

Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited

B

B

C

D

G

F

E

6.2.1.2.

CLEANING THE EXCHANGER AND PIPE UNIT

(SUITE/MUSA and CLUB):

CLEANING THE UPPER COMPARTMENT
When the stove is cold, remove the top, remove the ceramics/ sides as

described in section.3.3., loosening the relative fastening screws before

removing the drivers “B” and then remove the boiler cover “C”. At this

point, remove the turbulators “D” and using a rigid rod or a bottle

brush, clean the internal pipe unit and the turbulators, removing all of

the accumulated ash.
Check the cover gasket and replace it if necessary

ATTENTION: It is advisable to carry out the cleaning of the

upper exchanger at the end of the season and possibly by an
authorised MCZ technician in order to replace the gasket that

is below plug “C”. (fig.16a).


CLEANING THE LOWER COMPARTMENT
Remove the ash drawer “G”, empty it and using the nozzle of a vacuum

cleaner remove any ash and soot that may have built up under the

drawer “G”. Also remove the grate “F” and clean it every 2/3 days as

explained in chap. 5.1.
Remove the drawer “E”, empty it and using the nozzle of a vacuum

cleaner remove any ash that may have built up in the housing of the

drawer “E”.

ATTENTION: It is advisable to carry out the cleaning of the

lower compartment “E” once a week and in any case

according to the fuel consumption.


Check the seal of the ceramic fibre gaskets on the plug and replace it if

necessary.
Check the seal of the door gasket and replace it if necessary.
At the end of the season it is necessary to clean the compartment

under the grate and the heat exchanger inside it.
This general cleaning should be carried out at the end of the season in

order to facilitate the general removal of all residues of combustion,

without waiting too long, because with time and humidity these

residues can become compacted.

Figure 16 – Cleaning the pipe unit,

turbolator

and

lower

compartment

(EGO/STAR)