MCZ Club HYDRO 15 kW - Manual (Page 36)

PELLET STOVES Chapter 5
INSTALLATION AND USE MANUAL page 36
Maintenance and cleaning Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
6.2.2.
REPLACEMENT OF OVERPRESSURE
SILICON DAMPER FOR COMBUSTION CHAMBER
The overpressures sillicon damper "G" for combustion chamber (fig. A)
shall be replaced with a new one yearly (during the periodical
maintainance) in order to keep the overpressure safety system efficient.
For replacement use the following instructions
 remove the top
 remove the first lateral ceramic covering / metal covering (in
accordance with the model)
 unscrew the screw-washer-damper-spacer shown in fig. A/C
(operate same way on both sides)
Install the new kit as follows:
 Prepare the screw-washer-damper-spacer alligned as shown in
fig.C and screw them in the structure.
screw it completely
Check now the proper compression of dampers, using the gauge
included in the kit:

lay the gauge on the lid (fig.B); the gauge has to lay completely,
while the head of the screw has to be in contact with the gauge.
If it's not the case, register the screw accordingly.
A
B
C
G