MCZ Club HYDRO 15 kW - Manual (Page 15)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 15
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
On the control panel of the stove, once the thermostat is connected,
the temperature detected by the probe will continue to appear;
however, in this case the temperature set on the thermostat will be
valid.
The activation of the thermostat (on/off) on the control panel or of the
accumulation tank is possible from the menu, settings, on/off option
thermostat or accumulation as explained in the diagram below.
Esc Set
< Setting >
21.0°C 21.04
OFF Mode:AUTO Menu
Temp:22°C Fan:A
Esc Set
< Setting >
Esc Set
< Thermostat > Esc ON OK
< Thermostat >
4.11.3. Automatic mode with AUTO-ECO
This mode changes stove operation in automatic mode. Upon reaching
the temperature set by the user, the stove goes to power 1 for a short
period of time. The stove comes back on automatically only when the
room/water requires heat again, but not before a period of time has
passed for the stove to cool off. This option is advisable only if the stove
works in rooms where there is low heat dispersion over time.