MCZ Club HYDRO 15 kW - Manual (Page 24)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 24
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
 FRIDAY  at home until 9:00, from 12:00 to 15:00 and from 18:00 on
 SATURDAY  at home only after 18:00
 SUNDAY  at home only after 14:00
Based on these times, from the table in paragraph 4.11.2 the daily
programmes are selected which best suit this routine.
 MONDAY  Programme 20
 TUESDAY  Programme 43
 WEDNESDAY  Programme 00
 THURSDAY  Programme 13
 FRIDAY  Programme 34
 SATURDAY  Programme 10
 SUNDAY  Programme 08
To activate this type of customised setting follow the instruction in par.
4.11.2 page 48.
4.17. SAFETY DEVICES
The stove is fitted with the following safety devices:
 SMOKE TEMPERATURE SENSOR.
Monitors the temperature of the smoke, and gives permission for
start-up or shuts the stove down when the smoke temperature
falls below the preset value.
 PELLET HOPPER TEMPERATURE SENSOR.
If the temperature exceeds the preset safety level, it immediately
shuts down the running of the stove, and has to be reset, after the
stove has cooled, before the it will restart.
 BOILER TEMPERATURE PROBE (ALARM A18)
If the temperature of the water approaches shutdown temperature
(95°C) the stove will shut down.
 WATER TEMPERATURE PROBE (ALARM A17)
When the water temperature reaches80°C the stove starts to
gradually decrease the power to 85°C. If85 °C is exceeded, a
safety shut down will occur and the stove will re-start when the
stove body has properly cooled.
 ELECTRICAL SAFETY
The stove is protected against violent surges of current by the
main fuse, which is located on the control panel at the rear of the
stove. Other fuses to protect the electronic boards are to be found
on the boards themselves.
 FAILURE OF THE SMOKE EXTRACTION FAN
If the fan stops, the electronic board shuts off the supply of pellets
in good time, and an alarm is displayed.
 BREAKDOWN OF THE REDUCTION MOTOR
If the reduction motor stops, the stove continues to function until it
has cooled down to the minimum level.