MCZ Omega '05 - Manual (Page 7)

PELLET STOVES Chapter 1
INSTALLATION AND USE MANUAL page
6
Warning and guarantee conditions Technical service – Rights reservedMCZ S.p.A. Reproduction prohibited
EN
G
L
IS
H
• The stove must be connected to an electrical system
which is equipped with an earth conductor, as laid down
in directives 73/23 EEC and 93/98 EEC.
• The system must be of adequate rated capacity for the
stated electrical power of the stove.
• Incorrect installation or faulty maintenance (not
conforming to the requirements set out in this booklet)
can cause harm to people, animals or property. In such
cases MCZ is absolved from any civil or criminal
responsibility.
1.2. OPERATING WARNINGS
• Shut the stove down in the event of a breakdown or
poor operation.
• Pellets must not be fed manually into the burner.
• The accumulation of unburned pellets in the burner
after repeated "ignition failures" must be removed
before lighting.
• Do not wash the inside of the stove with water.
• Do not wash the stove with water. Water may get into
the inside of the unit and damage the electrical
insulation, causing electrical shock.
• Do not expose the body to hot air for extended periods.
Do not overheat the room where you are and where
the stove is located. This may cause physical harm and
pose a health hazard.
• Do not expose plants and animals directly to the flow of
hot air. This may be harmful to plants and animals.
• Do not put anything in the hopper other than wood
pellets.
• Install the stove in a location which is suitable for
firefighting, and equipped with all services such as air
and electricity supply and provision for discharging
combustion gases.
• If the stove and the ceramic cladding are in storage, it
should be in a place that is free of humidity, and they
should not be exposed to temperature extremes.
• It is inadvisable to base the stove directly on the floor,
and if the floor is made of flammable material, it must
be suitably insulated.
• Do not light the stove with flammable materials if the
ignition system breaks down.
INFORMATION:
• In case of any problems, get in touch with your dealer,
or a qualified engineer authorised by MCZ, and if a
repair is necessary, insist on the use of original spare
parts.
• Only fuel recommended by MCZ must be used (for Italy
only pellets with a diameter of 6mm, for other European
countries with a diameter of 6-8mm) and provided
exclusively by the automatic supply system.