beautypg.com

Changing from automatic to manual mode, Automatic mode with eco-stop – MCZ Omega '05 User Manual

Page 35

background image

PELLET STOVE

Chapter 4

INSTALLATION AND USE MANUAL

page

34

Operation

Technical Service – Rights reserved MCZ S.p.A. – Reproduction prohibited

EN
G

L

IS

H

• Connect the two wires of the cable from the thermostat to the

terminal of the MCZ connector (not included with the stove).

Insert the connector in the appropriate serial socket located on

the back of the stove.

• In order for the stove to recognize the external thermostat,

press and hold the button scrolling through the temperature
values below 6°C until the message “REMOTE TEMP.”

appears. This means that the external thermostat is now active

and overrides the internal one.

4.9.3.3.

Changing from automatic to manual mode

To change back from MANUAL mode to AUTOMATIC mode, do the

following:
press and hold the button until the temperature is over 40°C. The
display will now show the message “MODE MANUAL” and the light

will come on.

4.9.4. Automatic mode with ECO-STOP

When this option is activated by the corresponding menu item, the

operation of the stove is modified in automatic mode. When the

temperature set by the user is reached (on either the internal or

external thermostat), instead of adjusting power, the stove goes off

and shows the message "ECO STOP”. It will light again when the room

required heating again (not before the period of time required for the

stove to cool off). This option is advisable only if the stove operates in

small, well-insulated rooms.

Example:
If the room temperature detected by the room probe located on the

stove is 15°C and the temperature set on the thermostat is 20°C, the

stove will ramp up to the 5th power and upon reaching the target

temperature of 20°C it will automatically shut off temporarily, displaying

the message “

Eco Stop”. When the room temperature drops below the

value set on the thermostat (e.g. 18°C) the stove will come back on

automatically, and it keeps running until 20°C is once again reached. If

the temperature read by the room probe goes above the value set on

the thermostat (e.g. 20-21°C) the stove stays off and the display shows

the message “

Eco Stop”

It must be remembered however that the temperature keyed into the

thermostat is only indicative, and it is up to the user to find the correct

setting in the location where the stove is installed (for example, to

achieve 20°C in the room, it may be necessary to set the thermostat to

25°C). In this mode, the user can light the stove by setting the

thermostat temperature to a value which is higher than room
temperature or by pressing button

to change over to "Off" mode

and subsequently, by pressing the same button, proceeding with

lighting.
However, i this last case, the stove will go back to MANUAL mode in

"ON 3" This means you will have to reset to AUTOMATIC mode if you

want the stove to be controlled by the thermostat.

Connection of external thermostat serial

connector in the special socket on the back of

the stove

Wiring from

external thermostat

MCZ serial

connector


MENU 5
SET
E C O - STOP

This manual is related to the following products: