MCZ Omega '05 - Manual (Page 33)

PELLET STOVE Chapter 4
INSTALLATION AND USE MANUAL page
32
Operation Technical Service – Rights reserved MCZ S.p.A. – Reproduction prohibited
EN
G
L
IS
H
4.9. OPERATING MODES
The SATURN and OMEGA-PLANET stoves basically have three operating
modes.
4.9.1. Manual and automatic
The stove can operate in one of these two different operating modes.
MANUAL mode allows only adjustment of the flame from power 1 to
power 5, ignoring any ambient temperature measurement. This mode
is indicated by the symbol on the display.
Automatic mode, on the other hand, lets you set the desired
temperature in the room of installation. The stove will control its power
autonomously in order to reach the established temperature. With this
mode you can also use an external thermostat as explained in
paragraph 4.9.3.2 of this manual.
At each lighting, the stove sets to the operating mode
that it was in the last time it shut down.
4.9.2. Manual mode
In this mode you can only vary the thermal power provided by choosing
the flame power.
Using the button
the 5 heating powers of the stove are adjusted. If
the stove is at power 3, for example, the sequence will be:
P3 →P4→P5 →P1→P2→P3 .
Ventilation is also partitioned into 5 speeds (plus the AUTO position),
and it is possible to change it as you like using the key
. If ventilation
is for example at power 3, the sequence will be:
SET VENTOLA 3 →4→5→AUTO→1→2→3 .
In the "AUTO" position, ventilation autonomously adapts to the flame
power
Examples: Flame power P1 = Ventilation at 1
st speed
Flame power P2 = Ventilation at 2 nd speed
……
Flame power P5 = Ventilation at 5 th speed
ATTENTION!
During stove operation, if there are conditions which
alter normal operating status, the main alarm
indicator light (6) will come on accompanied by a
beeping sound (see the paragraph "stove shutdown")
and the stove will react by starting the total
shutdown procedure.
If there is an electrical power outage during lighting
or operation of the stove, the stove will switch over to
cooling mode and it will start again when the
electricity supply is restored.
P – 3
SET
POWER
SET 1
FAN
Variation of fan speed
Variation of flame power
ALARM
NO
FIRE
Stove in alarm and in lockout status