beautypg.com

Attention, Alarm indications – MCZ Omega '05 User Manual

Page 40

background image

PELLET STOVE

Chapter 4

INSTALLATION AND USE MANUAL

page

39

Operation

Technical Service – Rights reserved MCZ S.p.A. – Reproduction prohibited

EN
G

L

IS

H

Attention!

If the stove is NOT used as described in this instruction

booklet, the manufacturer refuses to accept any responsibility

for damage to persons and property that may arise. The

manufacturer furthermore refuses to accept responsibility for

damage to persons and property arising from the failure to

observe all the rules contained in the manual and in particular:

Failure when carrying out works of maintenance,

cleaning and repair to adopt all necessary measures and

precautions

Tampering with the safety devices.

Removing the safety devices.

Failure to connect the stove to an efficient system for the

discharge of smoke.

Failure to check in advance that the room where the

stove is to be installed is adequately ventilated.

4.10.1.

Alarm indications

In the event that a running problem occurs, as the stove is equipped

with a computerised monitoring system, it informs the user via the

display (8) of the nature of the fault and where it has occurred.
The following table summarises the principal alarms which may be

indicated

Message on the

display (8)

Type of problem

Solution

ALARM

SMOKE DEPRESS.

Smoke extraction is low because of obstruction of
the flue or back-pressure

Check and clean the WHOLE flue system

ALARM

SMOKE FAN

Smoke fan jammed.
Fan speed too low

Replace the smoke fan

ALARM

SMOKE PROBE

Smoke sensor short circuit

Replace smoke sensor

ALARM

PELLET TEMP.

The temperature of the pellet hopper is above the
preset threshold

Heat exchanger not working.
No voltage at exchanger.
Check the parameters of the recipe used.

ALARM

NO START

Occurs on first failed attempt at lighting

Check level of pellets in hopper. Check/replace
spark plug.

ALARM

SMOKE TEMP

The smoke temperature has exceeded certain pre-
set limits

The stove will shut off automatically. Let the stove
cool off for a few minutes, then re-light it.

ALARM

NO FIRE

Occurs when the stove goes out and when the
temperature of the smoke sensor is below the
preset threshold.

Derives from a failure to light. See above.


ALARM
NO
FIRE

This manual is related to the following products: