beautypg.com

MCZ Omega '05 User Manual

Page 26

background image

PELLET STOVE

Chapter 4

INSTALLATION AND USE MANUAL

page

25

Operation

Technical Service – Rights reserved MCZ S.p.A. – Reproduction prohibited

EN
G

L

IS

H

4.2. CHECK PRIOR TO FIRST LIGHTING

Check that all the safety conditions described above have been met.
Make sure you have read and completely understood the contents of

this instruction booklet.
Remove everything from the stove firebox and door which might burn

(instructions and various adhesive labels).
Check that the grate A is properly positioned and rests firmly on the

base.

After long periods of disuse, remove from the hopper (using

a vacuum cleaner with an extension) any remains of

pellets which have lain there for some time, since they may

have absorbed moisture, which changes their original

characteristics and makes them unsuitable for burning.


Check that the electrical connection is correct (230 V 50 Hz), and turn

on the main switch located on the rear panel of the stove.
Check that on the control panel the display is lit up with the alternating

message

OFF / CURRENT TIME.

4.3. LOADING PELLETS

fuel is loaded from the upper part of the stove by opening the door.

Pour the pellets into the hopper. When empty it will hold about a 15 kg

sack.
It is easier to perform this task if it is done in two steps:

Pour half the contents into the hopper and wait for the fuel to

settle to the bottom.

Then pour in the second half.

Never remove the protective grille from inside the

hopper. When loading pellets, avoid the bag coming

into contact with hot surfaces.

4.4. CONTROL PANEL and REMOTE CONTROL

1

5

7

2

4

9

3

6

8

A

This manual is related to the following products: