MCZ Omega '05 - Manual (Page 27)

PELLET STOVE Chapter 4
INSTALLATION AND USE MANUAL page
26
Operation Technical Service – Rights reserved MCZ S.p.A. – Reproduction prohibited
EN
G
L
IS
H
BUTTONS
1. Decrease set temperature / navigation - menu modifications
2. Increase set temperature / navigation - menu modifications
3. Set stove power
4. Set fan power
5. Stove lighting / shutdown
6. Menu / selection
7. Infrared receiver
8. Indicators (see specification)
DISPLAY
9. Display
INDICATORS
Timer active/inactive
Sparkplug in operation
Cycle where the screw delivers pellets
Hot air fan in operation/stopped
Operation in manual mode
General alarm (see specification)
4.4.1. REMOTE CONTROL and BATTERY REPLACEMENT
BUTTONS
1. Scroll down through menu / decrease set
temperature
2. Increase set temperature / programming
functions
3. Increase stove power
4. Increase fan power
Button 2+3 Lighting / Shutdown
BATTERY REPLACEMENT
The battery operates with a 12V 8LR932 alkaline battery (like those
used in gate-opening remote controls) and it is advisable to replace it
annually.
Procedure for replacement:
Put the tip of a flathead screwdriver into slot (X) of the remote control.
Turn the screwdriver clockwise so as to pry out the lid (Y).
Pull the lid (Y) completely out and replace the battery, placing it so
that its (+) is aligned with the polarity (+) marked on the body of the
remote control.
Put back the lid (Y)
Dispose of used batteries in accordance with current regulations.
4.5. SETTINGS TO BE MADE PRIOR TO FIRST
LIGHTING
Set the main switch on the rear of the stove to position (I).
The display (8) on the control panel will show the alternating message
OFF / CURRENT TIME.
If the time shown is not correct, it can be reset by the procedure
described below.
Keep in mind that the exact time is needed only when you perform
weekly programming with the TIMER (see relative chapter). On the
other hand, if the time is not up-to-date, this does not in any
compromise the operation of the stove.
4.5.1. Setting current time
Press the MENÙ key twice. The display will show the message SET
DAY and it is possible to set the day of the week using the buttons or
2 3
1 4
X
Y
Polarity +
SWITCH
12:
HOUR
LUN
SET
DAY