Epson FX-870/1170 - Manual (Page 33)

Printer Features
To change the settings shown in Table 1-17, Group 2 Features
mode),
or in
Table l-18, Group 2 Features mode),
follow the steps below:
1.
Turn on the printer while pressing the FONT and PAUSE buttons. The printer
beeps once and prints the current character table for either ESC/P or IBM mode
on the paper loaded in the paper path.
2. Press the FONT button to select the character table. The FONT, CONDENSED,
and BEADY turn on, off, or blink to show your selection. Press the FONT
button as many times as necessary until the FONT, CONDENSED, and BEADY
indicate the character set you want.
3. Turn off the printer. The settings are stored in non-volatile memory.
1-17.
Character Table I
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
ON
ON
OFF
OFF ON
BLINKS
I t a l i c U.S. (standard setting)
France
ON
ON
ON OFF
ON
BLINKS
BLINKS
BLINKS OFF
ON
BLINKS
OFF
OFF
OFF
ON
ON
ON
BLINK
BLINKS
OFF
Germany
U.K.
Denmark
Sweden
Spain
Italy
Character table PC437
ON
BLINKS
OFF
ON
BLINK
OFF
PC850
PC860
PC863
PC865
I
Abicomp
Note: When the character table is selected, that is assigned as the table
selected by tl command. Then ESC tl and ESC 6 are set as defaults.
(Codes are printable characters.)
Epson 1-21