Epson 386SX - Manual (Page 56)

2. To select
Hard disk drive,
press Enter. You see a
menu such as the following:
Change settings
** SAVE SETTINGS **
Drive 1: Type 17
Number of cylinders 977
Number of heads 5
Number
of sectors 17
Precomp. cylinder 300
Landing zone 971
Total capacity (MB) 40.5
Drive 2: None
Number of cylinders 0
Number of heads 0
Number of sectors 0
Precomp. cylinder 0
Landing zone 0
Total capacity (MB) .0
The submenu lists the settings you can change for each
drive: the number of cylinders (tracks), the number of read/
write heads, the number of sectors, the precompensation
cylinder, the landing zone (the cylinder on which you want
to park the heads when moving the computer), and the
total storage capacity in megabytes.
3. If you want to change the settings for Drive 1 (which is
drive C on most computers), press Enter to highlight
Drive
1:. If you want to change the settings for
Drive 2, press Enter and then to highlight
Drive 2:.
4. Press Enter. You see this submenu:
5. If you want to change the drive type and the configuration
of the hard disk you are installing matches one of the drive
types listed in Appendix E, go to step 6.
2-18 Running the Setup Program