Sealey TS401 - Manual (Page 23)

22
Figure 4.7
In this mode, the tool will do TPMS test for each single wheel. Place
the tool alongside the valve stem and point toward the sensor
location and then press TEST button. Wait for test result before
moving the tool.
The tool will send LF signal to trigger the sensor. Depending on the
sensor type, the tool will activate the sensor on the first or last step.
Once the sensor is successfully activated and decoded, the tool will
display as below with an audible beep. (Figure 4.8)
Figure 4.8
Once the first sensor test is completed, the screen will hold for 3
seconds for data viewing and then switch to next sensor test. Follow
the same procedure for the other sensor tests.
The tool can save up to 5 TPMS sensor data records at each time.
Press the UP/DOWN or LEFT/RIGHT scroll button to turn over
data screens while viewing. If more than five records are stored, the
latest record will overwrite the first one.