Sealey EU908 - Manual (Page 79)

Figure 11.6
When the job is done successfully, the tool will display a
message to confirm.
Figure 11.7
If the job fails to finish, the tool will display a message to remind
user of a problem. After you exit the diagnosis program, please
repair the problem immediately.
Figure 11.8
Put in fitting/removal position
Positioning done.
To replace or remove the brake
cables, refer to the mechanical
schedule "Removal-replacement:
electric parking brake primary and
secondary cables"
Press any key to continue
Put in fitting/removal position
Activation done, a problem
occurred during the operation.
Press any key to continue
B. Cable tensioning
Once the brake cable is fit in, you would use this function to
adjust its tension. It will take a few seconds to execute this
command.
78