Sealey EU908 User Manual

Page 47

to reset these monitors, the vehicle must be driven through a
complete drive cycle with no trouble codes in memory. Times for
reset vary depending on vehicle.

Some latest vehicle models may support two types of I/M
Readiness tests:

A. Since DTCs Cleared - indicates status of the monitors since the

DTCs are erased.

This Drive Cycle - indicates status of monitors since the
beginning of the current drive cycle.

An I/M Readiness Status result of “NO” does not necessarily
indicate that the vehicle being tested will fail the state I/M
inspection. For some states, one or more such monitors may be
allowed to be “Not Ready” to pass the emissions inspection.

z “OK” -- Indicates that a particular monitor being checked has

completed its diagnostic testing.

z “INC” -- Indicates that a particular monitor being checked has

not completed its diagnostic testing.

z “N/A” -- The monitor is not supported on that vehicle.

1) Use the UP/DOWN scroll button to select I/M Readiness from

Diagnostic Menu and press OK button. (Figure 6.3)

2) Wait a few seconds while the scan tool validates the PID MAP.

3) If the vehicle supports both types of tests, then both types will be

shown on the screen for selection. (Figure 6.20)

……………

I/M Readiness

1.Since DTCs Cleared

2.This Drive Cycle

Figure 6.20