Sealey TA203 - Manual (Page 5)

4.20. Replacing The Fuses
 WARNING! To avoid electric shock, disconnect the test leads from any source of voltage before accessing the fuses.
4.20.1. Disconnect the test leads from any item under test and disconnect them from the meter.
4.20.2. Open the battery door by loosening the screw using a Phillip’s screwdriver.
4.20.3. Remove the old fuse from its holder by gently pulling it out.
4.20.4. Install the new fuse into its holder.
Note: Always use a fuse of the correct size and value.
0.5A/250V fast blow for the 400mA range.
20A/250V fast blow for the 20A range.
4.20.5. Replace the battery cover and secure with the screw.

WARNING! To avoid electric shock, DO NOT use the meter until it has been fully re-assembled.
fig.6
The program is now ready to capture data from the TA203.V2.
For more details on using the program please refer to the document located in "C:\Program Files\9995" called "9995.rtf".
fig.5.
 WARNING! DO NOT attempt to repair or service your meter unless you are qualified to do so and have the relevant calibration, performance test,
and service information. To avoid electrical shock or damage to the meter do not get water inside the case.
5.1. Periodically wipe the case with a damp cloth and mild detergent. Do not use solvents.
5.2. Turn the meter off when not in use and remove the battery if stored for a long period of time.
5.3. Do not store the meter in a place of high humidity or high temperature
5. MAINTENANCE
Original Language Version © Jack Sealey Limited TA203.V2 Issue No: 3(L)- 17/06/14