Extron electronic FOX 2G Tx - Manual (Page 49)

FOX 2G Tx/Rx AV • Configuration 3-21
Firmware for FOX 2G Tx/Rx AV
Firmware can be downloaded onto the unit from the Extron Web
site (www.extron.com). The transmitter and receiver require
different firmware and must both be upgraded separately.
SIS Command Validity Table
If only one fiber optic channel is enabled, the ability to configure
the system through SIS commands is limited by the lack of
return communication from the receiver to the transmitter.
All commands issued through the transmitter are valid because
link 1 allows signals to be forwarded to the receiver. However,
responses to queries originating from the transmitter about the
status of the receiver will return invalid data.
All configuration of the receiver by commands issued through
the receiver will be valid. Attempts to configure the the
transmitter through the receiver in the absence of link 2 will be
invalid.
The following table shows the validity of commands issued
through the receiver when only link 1 is active:
Adjustment
Color
Valid
Tint Valid
Brightness Valid
Contrast Valid
Audio gain/
attenuation
Invalid
Audio mute Valid
Audio output level Valid
Output configuration Valid
Input configuration Invalid
Daisy chain mode Valid
Test pattern Valid
Video mute Valid