EnGenius Technologies ECB-1220R - Manual (Page 11)

ECB-1220R 11b/g Wireless Client Bridge/AP/Router/Repeater Version 1.1
11
2 Understanding the Hardware
Hardware Installation
1 Place the unit in an appropriate place after conducting a site survey.
2 Plug one end of the Ethernet cable into the RJ-45 port of the device and another
end into your PC/Notebook.
3 Insert the DC-inlet of the power adapter into the port labeled “DC-IN” and the
other end into the power socket on the wall.
This diagram depicts the hardware configuration
IP Address Configuration
This device can be configured as a Client Bridge or Access Point. The default IP
address of the device is 192.168.1.1 or 192.168.1.2. In order to log into this device,
you must first configure the TCP/IP settings of your PC/Notebook.
1. In the control panel, double click Network Connections and then double click on
the connection of your Network Interface Card (NIC). You will then see the
following screen.
Bridge/AP PC
Power Outlet
Ethernet
AC/DC cable