Epson STYLUS RX500 - Manual (Page 64)

64 Scanning by using the LCD panel and buttons
4. Remove the film holder from the document cover.
5. Load the transparency into the film holder and position it on the
document table. Go to the section listed below that matches the
type of transparency you want to scan. See the following sections
for details.
❏ “35 mm film strips” on page 65
❏ “35 mm slides” on page 66
Note:
❏ The base side of the film is the side where the film maker's name
and film ID numbers can be read correctly. Also, when you look at
an image on the film from the base side, the image should appear
normally, not as the reverse of it.
❏ Set the film correctly in the film holder and position the film holder
properly on the document table.
❏ Do not press the glass of the document table with too much force.