Upc-ean general symbology properties – Casio Naurtech CETerm Ver.5.5 Scripting Guide User Manual
Page 138

UPC-EAN
G
ENERAL
S
YMBOLOGY
P
ROPERTIES
UPC-EAN general symbology properties are unique for each session.
Symbology properties begin with “sessionX.scanner.upc-ean” where X is 1
through. For example “session4.scanner.upc-ean.bookland”. If no „X‟ value is
found, the currently active session number is used.
NOTE: If you are changing the symbology properties for the currently active
session, you must call “CETerm.PostIDA(
“IDA_SCAN_APPLYCONFIG”, 0 ) for the changes to take effect.
WARNING: Not all properties are applicable to all hardware devices. Different
devices may use different names to refer to the same parameters.
You should look at the settings available in the CETerm configuration
dialogs to determine if the property is appropriate and what values it
may accept.
Last Property Level
Description
bookland
Enable Bookland labels. T/F
coupon
Enable Coupon labels. T/F
lineardecode
Enable linear decode. T/F
supplemental2
Enable 2 digit supplemental or add-on barcode. T/F
supplemental5
Enable 5 digit supplemental or add-on barcode. T/F
supplementalretry
Supplemental decode retry count. 2-10
randomweightcheckdigit Enable random weight check digit. T/F
supplementalmode
Supplemental mode. none, always, auto
securitylevel
Decode security level. none, all, ambiguous