Casio Naurtech CETerm Ver.5.5 Scripting Guide - Manual (Page 133)

S
CANNER
P
ROPERTIES
Scanner properties are unique for each session. Scanner properties begin with
“sessionX.scanner” where X is 1 through 4. For example
“session4.scanner.enabled”. If no „X‟ value is found, the currently active session
number is used. We use the name “scanner” for all types of barcode readers,
including laser scanners and imagers. If a hardware vendor is listed, the
property is specific to barcode readers made by that vendor.
NOTE: If you are changing the scanner properties for the currently activesession,
you must call CETerm.PostIDA( “IDA_SCAN_APPLYCONFIG”, 0 ); for
the changes to take effect.
WARNING: Not all properties are applicable to all hardware devices. Different
devices may use different names to refer to the same parameters.
You should look at the settings available in the CETerm configuration
dialogs to determine if the property is appropriate and what values it
may accept.
Property Name Description
sessionX.scanner.enabled Scanner is enabled. T/F
sessionX.scanner.aimerenabled Aimer is enabled. T/F
sessionX.scanner.wedgeenabled Allow wedge if scanner disabled in CETerm
(Intermec). T/F
sessionX.scanner.focusnear Imager focus near if true. T/F
sessionX.scanner.enhanced1d Improved decode for poor quality barcodes
sessionX.scanner.negativelabel Improved decode negative barcodes T/F
sessionX.scanner.picklistmode Decode barcode under cross-hairs. T/F
sessionX.scanner.preamble Barcode preamble
sessionX.scanner.postamble Barcode postamble
sessionX.scanner.grid Barcode grid filter (Intermec) Use
OnBarcodeRead for more features.
sessionX.scanner.beamtimeout Scan beam timeout, milliseconds
sessionX.scanner.aimertimeout Aimer timeout, milliseconds
sessionX.scanner.aimmode Aim mode. none, dot, slab, reticle
sessionX.scanner.redundancy Linear security/redundancy, 0-5