Casio Naurtech CETerm Ver.5.5 Scripting Guide - Manual (Page 137)

C
ODE
128 S
YMBOLOGY
P
ROPERTIES
Code 128 specific symbology properties are unique for each session.
Symbology properties begin with “sessionX.scanner.code128” where X is 1
through. For example “session4.scanner.code128.ISBT”. If no „X‟ value is
found, the currently active session number is used.
NOTE: If you are changing the symbology properties for the currently active
session, you must call “CETerm.PostIDA(
“IDA_SCAN_APPLYCONFIG”, 0 ) for the changes to take effect.
WARNING: Not all properties are applicable to all hardware devices. Different
devices may use different names to refer to the same parameters.
You should look at the settings available in the CETerm configuration
dialogs to determine if the property is appropriate and what values it
may accept.
Last Property Level Description
FNC1char FNC1 character. 0-255
CIP Enable CIP labels. T/F
ISBT Enable ISBT 128 labels. T/F
other Enable other 128 labels. T/F
UCCEAN Enable UCCEAN 128 labels. T/F