Casio YA-S10 User Guide - Manual (Page 7)

7
Capturing a Screen and Saving It as the Custom Logo
Important!
z As soon as you start a screen capture with the operation below, any custom logo currently
stored in Control Box memory is deleted.
z If the capture operation is interrupted for any reason before it is complete, your custom logo
data will revert to the initial factory default image (light green image). However, depending on
the timing of the interruption, you may end up with a partial capture with part of the screen
image being registered as your custom logo.
1.
Project the image you want to register a custom logo onto the projection screen.
z If you are using an RGB or HDMI (PC) input source, use a resolution that is one of the
following: 1366 Ч 768, 1360 Ч 768, or 1280 × 800 or lower. You will not be able to execute the
screen capture operation if the projected image resolution is not one of those defined above.
z Only the following component signals are supported for capture: 480i, 480p, 576i, 576p.
Capture cannot be performed using an input source with a component signal that is not one of
these.
z Capture cannot be performed while protected contents are being projected.
2.
Press the [MENU] key to display the setup menu.
3.
Select “Option Settings” and then press the [ENTER] key.
4.
Select “Custom Logo Capture” and then press the [ENTER] key.
5.
In response to the “Starts capture of the current screen. OK to continue?” dialog
box that appears, select “Yes” and then press the [ENTER] key.
z The image being projected at the moment you press the [ENTER] key will become frozen on
the screen and capture will begin.
z If the image is saved successfully, the message “Screen capture complete.” will appear
momentarily.
Specifying a Custom Logo as the No Signal Screen or Blank Screen
Press the [MENU] key to display the setup menu and then perform one of the procedures below.
z Use “Screen Settings 3 No Signal Screen” (page 9) to select “Custom Logo”.
z Use “Screen Settings 3 Blank Screen” (page 9) to select “Custom Logo”.