Important – Casio YA-S10 User Guide User Manual
Page 10
10
Option Settings 3
Custom Logo Capture
See “Creating a Custom Logo” (page 6).
Option Settings 3
Remote Power Numbers
Specify which of the remote controller’s power buttons ([1], [2], [3], [4]) turns on the
Control Box. See “Control Box Power On/Off” in the YA-S10 Setup Guide.
Option Settings 3
Language
Specify the display language.
English, French, German, Italian, Spanish, Swedish, Portuguese, Dutch, Norwegian,
Polish, Finnish, Czech, Turkish, Russian, Chinese (Simplified), Chinese (Traditional),
Korean, Japanese
Option Settings 3
Restore Menu Defaults
Return the “Eco Mode”, “Auto Power Off”, “Direct Power On”, and “Remote Power
Numbers” settings to their initial defaults. When the input source is RGB, this
operation also initializes the “Auto Adjust” setting. This operation does not clear a
custom logo saved with “Custom Logo Capture”.
Wired LAN settings 3
Remote On
Specify whether or not Control Box power can be turned on remotely via wired LAN.
Selecting “Enable” enables remote on, while “Disable” disables it.
Important!
This item automatically becomes “Disable” following a “Wired LAN settings 3
Initialize wired LAN settings” or “Restore All Defaults 3 Restore All Defaults”
operation. If you are operating the Projector System using a wired LAN setting,
be sure to change this setting back to “Enable” after initialization.
Wired LAN settings 3
Wired LAN info
Display the information described below.
Wired LAN settings 3
Initialize wired LAN settings
Initialize the “Remote On” setting and Control Box LAN settings (see “LAN Settings”
on page 13).
Operational Info
Display the information below. Resolution information is available only when the
input source is RGB or HDMI (PC).
Input Signal, Signal Name, Resolution, Horizontal Frequency, Vertical Frequency,
Scan System, Light Time (A), Light Time (B)
Restore All Defaults 3
Restore All Defaults
Initialize all Setup Menu item settings, except for those listed below.
– Screen Settings 3 Image Shaping
– Option Settings 3 Language
– Custom logo saved with “Custom Logo Capture”
*1 The setting of this item cannot be configured when the Control Box is connected to any one of the
projector models below.
XJ-A131, XJ-A141, XJ-A146, XJ-A241, XJ-A246, XJ-A251, XJ-A256
You can use the projector’s remote controller to change the corresponding settings on the projector.
Use this menu item:
To do this:
Box Name:
Control Box name
MAC Address: Control Box unique MAC address
IP Address:
Control Box IP address