Casio YA-S10 User Guide - Manual (Page 4)

4
1.
Press the [INPUT] key.
2.
On the “Input” dialog box that appears, select the input source you want and
then press the [ENTER] key.
If the image of an RGB signal being input from a computer is not being projected correctly, press the
[AUTO] key to adjust it automatically. If this does not improve the image, check the points described
below.
z Check to make sure that the signal is a type that is supported by the Control Box. See “Supported
Signals” (page 18) for more information.
z On the Setup Menu, change the “Option Settings 3 Auto Adjust” setting (page 9).
Pressing the [BLANK] key cuts off the image and the audio * 1 from the input source. This will cause the
projected image to change to a black screen (initial default option), blue screen, a preset logo, or a
custom logo.
* 2
To restore the image and audio, press the [BLANK] key again or press the [ESC] key.
Pressing the [FREEZE] key freezes the current input source image. To return to the real-time input
source image, press the [FREEZE] key again or press the [ESC] key.
To change the input source (INPUT)
Adjusting an RGB Input Signal Automatically (AUTO)
Blanking the Image and Muting the Audio (BLANK)
*1 The Projector System connected to the Control Box will output audio from projector speakers
when an HDMI input source is selected.
*2 Blank screen projection can be configured using the “Screen Settings 3 Blank Screen” setting
(page 9).
Freezing an Image (FREEZE)