Casio YA-S10 User Guide - Manual (Page 6)

6
Use the procedures below to adjust the volume level of the audio that is output by the projector
speakers, or to mute audio output.
Note
The projector outputs audio only when HDMI input is selected with the Control Box and an HDMI
audio signal is being input to the Projector System.
To adjust the volume level of the projector speakers
1.
Press the [MENU] key to display the setup menu.
2.
Select “Volume Adjustment” and then press the [ENTER] key.
3.
Use the [
W] and [X] keys to adjust the volume level. When it is at the setting you
want, press the [MENU] key.
To mute projector speaker output
1.
Press the [MENU] key to display the setup menu.
2.
Select “Volume Adjustment” and then press the [ENTER] key.
3.
Select “Mute” and then press the [
W] and [X] keys to change the setting to “On”.
4.
Press the [MENU] key.
To unmute projector speaker output, use the [ W] and [X] keys in step 3 of the above procedure to
change the setting to “Off”, or perform the operation under “To adjust the volume level of the projector
speakers”.
You can capture a projected screen and save it as image data in the Control Box’s built-in memory.
Image data you save in Control Box memory is called a “Custom Logo”.
The following are ways you could use a custom logo.
– As the “No Signal Screen”, which is projected whenever there is no signal being input into the
Control Box.
– As the “Blank Screen”, which is projected when the [BLANK] key is pressed.
Important!
Note that using the Control Box to register image data for commercial purposes or public
presentation may infringe on the legally protected copyright of the copyright holder of the
original material.
Adjusting the Volume Level
Creating a Custom Logo