Casio YA-S10 User Guide - Manual (Page 15)

15
Only the following functions are supported while the Control Box is turned off. Do not try to send any
other command to the Control Box.
z Power On/Off: Read
z Power On: Write
R: Read enabled W: Write enabled
Command List
Function Command RW Setting Range
Power On/Off: PWR RW 0: Off, 1: On
Input Switching:
0: Switches the input source to the COMPUTER terminal and
changes the COMPUTER terminal setting to RGB.
1: Switches the input source to the COMPUTER terminal and
changes the COMPUTER terminal setting to Component.
6: Switches the input source to the COMPUTER terminal and
changes the COMPUTER terminal setting to Auto.
7: Switches the input source to HDMI.
SRC RW 0: RGB, 1: Component,
6: Auto1 (RGB/Component),
7: HDMI
Blank Screen:
Turns the blank screen on or off. BLK RW 0: Off, 1: On
Volume:
Specifies the volume level for output of HDMI audio input to
the Control Box when it is output from projector speakers or
line output. VOL RW 0 to 30 * 1
Color Mode:
Selects the color mode. PST RW 1: Graphics, 2: Theater,
3: Standard, 4: Blackboard,
5: Game
Aspect Ratio:
Specifies the aspect ratio.
* 2
ARZ RW 0: Normal, 1: 16:9,
3: Letter Box, 4: Full
Get Light Time:
Executing this command gets the light use time of the
projector connected to the Control Box. If there are two
projectors, it gets the larger light use time of the two. LMP R 0- Unit: Hours
*1 The maximum allowable volume level value depends on the connected projector(s).
*2 This setting is equivalent to the setting configured with “Changing the Aspect Ratio of the Input
Source Image (ASPECT)” (page 5).