Epson 8900 Series - Manual (Page 20)

Line Feed and Carriage Return Upon Receipt of CR
When on, this parameter causes the printer to perform both an LF
operation and a CR operation upon receiving a CR command from
the host computer. The default setting is OFF.
Carriage Return Upon Receipt of LF, VT, or DC2
When on, this parameter causes the printer to perform a CR operation
upon receiving any of the following commands.
q Line feed (LF) — The printer moves the printhead down to the
next print line and returns the carriage to the left margin.
q Vertical tabulation (VT) — The printer prints the remainder of
the current print line, moves the printhead down to the next
vertical tab stop, and returns the carriage to the left margin.
q Device control 2 (DC2) — The printer moves the printhead
down to the print line specified by the DC2 n (Move to Line n)
command and returns the printhead to the left margin.
The default setting for the parameter CR W/LF VT DC2 is OFF.
Graphics
When on, this parameter enables the raster graphics escape sequences
described in Chapter 4. The default setting is OFF.
Shift Out Equals Expanded Print
When on, this parameter causes the printer to print one line of
expanded print after receiving a shift out (SO) command. When this
parameter is off, the printer invokes the G1 character set into the GL
area of the character table upon receiving SO. The default setting is
OFF.
Printer Setup 2-7