Epson 8900 Series - Manual (Page 126)

TI Model 855 Printer DP Emulation 6-13
Set Vertical Tab Stops
Escape sequence: ESC B n1...n16 NUL
Hexadecimal: 1B 42 n1...n16 00
This command clears all previously set vertical tabulation stops and
sets a new stop at each of the lines specified by the variables
n1...n16. Each of the variables n1 through n16 can range from 1
through 127 for 7-bit character sets and 1 through 255 for 8-bit
character sets. However, the printer ignores any setting below the
bottom print line.
Clear All Vertical Tab Stops
Escape sequence: ESC B NUL
Hexadecimal: 1B 42 00
Character Pitch Commands
The following paragraphs describe the commands for character pitch
operations in the Model 855 DP emulation mode.
Set Character Pitch to 10 cpi
Escape sequence: ESC y
Hexadecimal: 1B 79
Set Character Pitch to 12 cpi
Escape sequence: ESC z
Hexadecimal: 1B 7A
This command sets the character pitch to 12 cpi.
Line Spacing Commands
The following paragraphs describe the commands for line spacing
operations in the Model 855 DP emulation mode.
Set Line Spacing to 6 lpi
Escape sequence: ESC 2
Hexadecimal: 1B 32