Epson StylusPro10000 - Manual (Page 54)

2-8
2-8 | Handling Paper and Other Media
When you’re not using the roll paper belt, keep it wound around the end of
the spindle.
Removing Paper from the Spindle
If you need to remove the paper roll from the spindle, follow these steps:
1. Open the roll paper cover and lift out the roll and spindle. Lift out the
left end of the spindle and roll first, and then the right end.
If the paper is loaded for printing, pull the paper set lever out to the
released position, then roll up the paper before you remove the spindle.
2. Lay the roll down on a flat surface.
3. Loosen the movable paper stop by tapping it with your hand.
4. Slide the paper stop off the end of the spindle.
5. Remove the roll from the spindle.
roll paper belt
Caution
To avoid damaging the
printer, never move the
paper set lever while
the Operate or Pause
light is flashing.
To avoid damaging the
spindle, do not tap the
end of the spindle
on the floor.