Epson StylusPro10000 - Manual (Page 30)

1-12
1-12 | Setting Up the Printer
Connecting to a Parallel Port (Windows Only)
To use the printer’s built-in parallel interface, you need a shielded,
bidirectional, parallel cable. Follow the steps below to connect the printer to
your computer:
1. Make sure both the printer and your computer are turned off.
2. Plug the cable connector securely into the printer’s interface. Then
squeeze the wire clips together until they lock into place on both sides.
3. Plug the other end of the cable into the computer’s parallel port.
Connecting to the IEEE 1394 (FireWire) Port
To connect the printer to the IEEE 1394 port, you need a standard shielded
IEEE 1394 cable. Follow the steps below to connect the printer to your
computer.
1. Make sure both the printer and your computer are turned off.