Lanner FX-3210 - Manual (Page 11)

6
Hardware Setup
Chapter 2
Network Application Platforms
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server. The front panel Power On/Standby button
does not completely shut off system power.
Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Unpower the FX-3210 and remove the power cord. 1.
Unscrew two screws on the back of top cover . 2.
Slide the cover backwards and open the cover 3.
upwards.
Installing the System Memory
The motherboard supports DDR3 memory that features
data transfer rates of 1066, 1333 or 1600 MHz to meet the
higher bandwidth requirements of the latest operating
system and Internet applications. To install the memory:
Open the DIMM slot latches. 1.
Install the DIMM. 2.
Note:
All DIMMs installed must be the same speed 1.
(DDR3 1066, 1333 or 1600, unbuffered ECC or
non-ECC). Do not install DIMMs supporting
different speeds. The DDR3 1600 is supported on
the Ivy Bridge platform only.
The system can support up to 32 GB in maximum. 2.
Since the system is capable of Dual Channel 3.
Architecture, some installation guidelines have to
be met to enable Dual Channel mode as directed.
To insert two DIMMs on the system, insert DIMMS
on slot J2 (blue) and J4 (blue). And use slot J3
(black) and J5 (black) if more slots are required.
(Use slot J3 and then slot J5 in sequence for the
additional DIMMS.)
1
2 1
1
2