Lanner FW-7540 - Manual (Page 23)

18
Bios Settings
Chapter 4
Network Application Platforms
Advanced Settings
Select the Advanced tab from the setup screen to enter
the Advanced BIOS Setup screen. You can select any of
the items in the left frame of the screen, such as SuperIO
Configuration, to go to the sub menu for that item. You
can display an Advanced BIOS
Setup option by highlighting it using the keys.
All Advanced BIOS Setup options are described in this
section. The Advanced BIOS Setup screen is shown at
the right. The sub menus are described on the following
pages.
IDE Configuration Settings
You can use this screen to select options for the IDE
Configuration Settings. Use the up and down
keys to select an item. Use the and keys to
change the value of the selected option. A description of
the selected item appears on the right side of the screen.
The settings are described on the following pages. An
example of the IDE Configuration screen is at the right.
ATA/IDE Configuration
Configure SATA as:
Option Description
IDE If you want to use the Serial-ATA
hard disk drives as Parallel ATA
physical storage devices, keep
the default setting IDE.
AHCI If you want the Serial-ATA hard
disk drives to use the Advanced
Host controller Interface (AHCI),
set this item to AHCI. The AHCI
offers the following advantages:
No master/slave designation •
for SATA devices–each de-
vice is treated as a master.
Hardware assisted native
•
command queuing
Hot-Plug support
•