Lanner FW-7540 - Manual (Page 11)

6
Hardware Setup
Chapter 2
Network Application Platforms
Installing the Hard Disk
The system can accommodate one Serial-ATA disk (2.5”).
Follow these steps to install the hard disk into the FW-
7540:
Insert the anti-vibration rubber to the hard disk 1.
securing bracket. Make sure that the rubber goes
through the holes when inserting it.
Attach the hard disk to the securing bracket by
2.
fastening 4 screws to the lateral sides of the hard disk .
Connect the Serial-ATA cable to the hard disk.
3.
Connect the Serial-ATA power cable and the data cable 4.
to the main board.
Place the hard disk with the securing bracket and install
5.
it onto the system by fastening it with four screws.
Installing a CompactFlash Card
FW-7540 provides one CompactFlash slot. Follow the
procedures bellow to install a CompactFlash card.
Align CompactFlash card and the card slot with the 1.
arrow pointing toward the connector.
Push the card to insert into the connector.
2.
1
2
Note: Connect the Serial-ATA cables to the main
board first before installing the hard disk to the
system to avoid blockage of the connectors.
3
4
2
1
Hard disk securing
brackets
SATA cables
5