Lanner FW-7540 - Manual (Page 12)

7
Hardware Setup
Chapter 2
Network Application Platforms
Installing 3G SIM Card
Installing Wireless 3G Module
Align the wireless module’s cutout with the Mini-PCIe 1.
slot notch.
Insert the wireless module into the connector
2.
diagonally.
Push the other end of the wireless module to be
3.
tightened with the latch.
Unlock the SIM card tray. 1.
Align the SIM card and the tray with the cut-off 2.
angle.
Insert the SIM card into the tray.
3.
Close the tray and lock it on the board. 4.
Mounting
Tabletop Mounting
To mount the FW-7540 on the table, use the rubber feet
in the tabletop mounting pack. Follow the following
procedures as a guideline:
Place the rubber feet on the mounting spots at the 1.
bottom of the FW-7540 .
Place the FW-7540 on the table with the rubber feet 2.
standing on top of the table.
Rack Mounting
Installation environment precaution:
Elevated Operating Ambient - If installed in a 1.
closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment
may be greater than room ambient. Therefore,
consideration should be given to installing
the equipment in an environment compatible
with the maximum ambient temperature (Tma)
specified by the manufacturer.
Reduced Air Flow - Installation of the equipment 2.
in a rack should be such that the amount of air
flow required for safe operation of the equipment
is not compromised. Mechanical Loading -
Mounting of the equipment in the rack should
be such that a hazardous condition is not created
due to uneven mechanical loading.
Mechanical Loading - Mounting of the equipment 3.
in the rack should be such that a hazardous
condition is not achieved due to uneven
mechanical loading.
Circuit Overloading - Consideration should be 4.
given to the connection of the equipment to the
supply circuit and the effect that overloading
of the circuits might have on over-current
protection and supply wiring. Appropriate
consideration of equipment nameplate ratings
3
4
3
2
Note: To remove the SIM card, unlock the tray first
by sliding it outward.
Note 1. : To remove the module from the system,
release the latch first by slightly bending it inward.