Lanner FW-7540 - Manual (Page 13)

8
Hardware Setup
Chapter 2
Network Application Platforms
should be used when addressing this concern.
Reliable Earthing - Reliable earthing of rack- 5.
mounted equipment should be maintained.
Particular attention should be given to supply
connections other than direct connections to the
branch circuit (e.g. use of power strips).”
Mounting one system to the Rack
To mount the FW-7540 onto the rack, use the mounting
kit with the screw pack. Follow these procedures as a
guideline:
Attach the adaptor mounting bracket to the system by 1.
fastening 5 screws as shown in the figure.
Place the adaptor in the adaptor mounting bracket.
2.
Make sure that the power adaptor’s AC socket is not
blocked; to do os, align the AC socket with the holes
on the mounting bracket.
You could use the adaptor holder to hold your adaptor
3.
to prevent it from sliding back and forth in the picture
below.
Use 3 screws provided to fix the bracket to the left and
4.
right side of the system as shown in the picture.
Note:
Bracket mounting screws for mounting the
bracket onto the rack equipment are not included.
The original screw pack is for attaching the system
to the bracket.
Single system mounting kit
Installing Adaptor mounting bracket
Installing adaptor holder
Mounting long-ear bracket
Note:
Place the power adaptor in the bracket first before
installing the adaptor holder.
Rack mounting
Aligning power adaptor’s
AC socket with this hole