Yaskawa 260IF DeviceNet System - Manual (Page 54)

5.2 Message Send Function (MSG-SND)
5-5
5
5.2.3 Parameter List
The parameters displayed under “PARAM” are shown in the following table.
Processing Result (PARAM00)
The processing result is output to the higher-place byte. The lower-place byte is for system
analysis.
• 00xx: Processing (BUSY)
• 10xx: Processing completed (COMPLETE)
• 8xxx: Error (ERROR)
No IN/OUT Content Remarks
00 OUT Processing result
01 OUT Status
02 IN Remote node MAC ID
03 SYS Reserved for system use Reserved for system use
04 IN Function code
05 IN/OUT Data address
06 IN/OUT Data size
07 - Remote node CPU #
08 - Coil offset
09 - Input relay offset
10 - Input register offset
11 - Holding register offset
12 SYS For system use
13 SYS Reserved for system use Reserved for system use
14 SYS Reserved for system use Reserved for system use
15 SYS Reserved for system use Reserved for system use
16 SYS Reserved for system use Reserved for system use
17 SYS Reserved for system use Reserved for system use