SMA SB 700U - Manual (Page 45)

SB700U-11:SE3207 SMA America 4-21
should face the LID.
5. While holding the cover in place, carefully insert the four screws with lock
washers through the holes in the cover into the threaded holes in the case and
turn them in until they are finger-tight. Be careful not to cross-thread any of the
screws.
6. Verify that the cover is in the correct position and that the seal is in place
between the case and the cover.
7. Tighten the cover screws fully, and reinspect the seal to ensure that it is in the
correct position.