SMA SC 500CP-10-JP Mounting Instructions - Manual (Page 19)

SMA Solar Technology AG 6 Assembly
Mounting Instructions SCCP-JP-MA-Silence-en-10 19
6.5 Mounting the Kick Plate for the Sound Absorber
1. Apply metal-free allround paste to all threads in the base area.
2. Position and align the kick plate for the sound absorber on the
enclosure.
3. Screw pan head flange screws into the threads.
4. Tighten the pan head flange screws on the kick plate with a suitable screwdriver (torque: 8 Nm)
6.6 Mounting the Ventilation Plate
The guide rails for the ventilation plate are located in the floor area of the inverter cabinet.
Procedure:
• Slide the ventilation plate into the guide rails in the inverter cabinet from the front. The ventilation grid in the
ventilation plate should be facing the rear panel.
☑ The ventilation plate is flush with the Sunny Central.
✖ The ventilation plate will not go all the way in?
• Grip the ventilation plate from underneath and press the middle part upwards while sliding it in.
6.7 Mounting the Kick Plates
1. Position and align the kick plates with soundproofing material on the enclosure.
2. Screw the previously retained pan head flange screws into the threads.
3. Tighten the pan head flange screws on the kick plate with a suitable screwdriver (torque: 8 Nm)
6.8 Mounting the Silencing Baffle
Procedure:
To mount the silencing baffle, perform the following actions in the specified order. The exact procedure is described in
the steps below.
• Mounting the rear panel of the silencing baffle
• Mounting the lid of the silencing baffle
• Mounting the rain protection
Mounting the Rear Panel of the Silencing Baffle
Required mounting material:
☐ 2 cylinder head screws
☐ 2 contact washers