SMA SC 500CP-10-JP Mounting Instructions - Manual (Page 14)

6 Assembly SMA Solar Technology AG
14 SCCP-JP-MA-Silence-en-10 Mounting Instructions
6 Assembly
6.1 Disassembling the Kick Plates
The kick plates are mounted at the bottom front and rear of the inverter.
Figure 5: Position of the kick plates
Requirement:
☐ The additionally required mounting material must be available (see Section 5.1 "Additionally Required Mounting
Material", page 13).
/05*$&
Damage to the inverter through moisture or dust intrusion
During assembly work, the inverter is not sufficiently protected against dust and moisture. If the assembly work is carried
out during rainfall or in a dusty environment, moisture or dust can penetrate the inverter. This can damage the electronic
components or impair the functionality of the inverter.
• Make sure that no dust, moisture or foreign bodies are present in the inverter after assembly.
/05*$&
Damage to the inverter due to improper storage of the enclosure parts
Seals are to be found on the rear side of the enclosure parts. If the enclosure parts are not stored properly, these seals
may be damaged. If seals are damaged, this will compromise the weatherproof seal of the inverter. Dust and moisture
can penetrate the inverter.
• Store the enclosure parts properly.
• Replace damaged seals.
Take weather conditions into account
Before starting the assembly work, ensure that the weather conditions are suitable for opening the inverter. If this is
not the case, you must take appropriate measures to protect the inverter from inclement weather.
Position Designation
A Front kick plate on the inverter
B Rear kick plate on the inverter