SMA SC 500CP-10-JP Mounting Instructions - Manual (Page 15)

SMA Solar Technology AG 6 Assembly
Mounting Instructions SCCP-JP-MA-Silence-en-10 15
Procedure:
2. Remove all screws from the kick plates using a suitable screwdriver. Screwdriver: TX 30
3. Remove the four screws on each of the two front kick plates. Retain the screws for subsequent mounting of the new
kick plates.
4. Remove both front kick plates.
5. Remove the four screws on each of the two rear kick plates. Retain the screws for subsequent mounting of the new
kick plates.
6. Remove both rear kick plates.
7. Dispose of the kick plates.
6.2 Removing the Existing Ventilation Plate
1. Pull the ventilation plate forwards out of the base area of the inverter
cabinet. Grasp underneath the ventilation plate and press the
middle part up while pulling it out.
2. Dispose of the ventilation plate.
1. '$1*(5
Danger to life from electric shock due to live voltage
Prior to performing any work on the inverter, disconnect it from voltage sources (see inverter installation manual).