SMA SC 500CP-10-JP Mounting Instructions - Manual (Page 16)

6 Assembly SMA Solar Technology AG
16 SCCP-JP-MA-Silence-en-10 Mounting Instructions
6.3 Disassembling the Rear Panel
Figure 6: Illustration of the rear panel to be disassembled
Requirements:
☐ Two persons must be available for disassembling the rear panel.
☐ The required mounting material must be available.
☐ A storage location for the enclosure parts must be available.
☐ The inverter must be sufficiently protected from inclement weather.
Procedure:
2. Secure the rear panel of the inverter from slipping off.
3. Unscrew all ten screws of the rear panel using a suitable
screwdriver. Screwdriver: TX 30
4. Remove all screws from the rear panel and retain for later use.
&$87,21
Danger of crushing caused by heavy, bulky rear panel
The rear panel of the inverter weighs up to 20 kg. If the rear panel slips or jams, limbs could be crushed.
• Always have two persons available for assembling and disassembling the enclosure parts.
• When carrying out any work on the inverter, always wear suitable personal protective equipment.
1. '$1*(5
Danger to life from electric shock due to live voltage
Prior to performing any work on the inverter, disconnect it from voltage sources (see inverter installation manual).