HEIDENHAIN IK 5293 - Manual (Page 402)

388
Chapter 8 Setup
To square axes
Step 1
Enter the length of the bar-ball at the 45 degree orientation in the radial text box
for the XY plane.
Step 2
Enter the length of the bar-ball at the 135 degree orientation in the tangent text
box for the XY plane.
NOTE NOTE NOTE NOTE NOTE
Use the same procedure to square the other axes. Use the same procedure to square the other axes. Use the same procedure to square the other axes. Use the same procedure to square the other axes. Use the same procedure to square the other axes.