HEIDENHAIN IK 5293 - Manual (Page 220)

206
Chapter 5 Advanced Measuring & Output
Step 4
Enter the specified diameter as shown.
Step 5
Type in the nominal + and nominal - values for your feature as shown.
NOTE NOTE NOTE NOTE NOTE
Nominal + and - values are the same as the tolerance value for Nominal + and - values are the same as the tolerance value for Nominal + and - values are the same as the tolerance value for Nominal + and - values are the same as the tolerance value for Nominal + and - values are the same as the tolerance value for
the feature. F
the feature. F the feature. F the feature. F the feature. For example, if a feature has a tolerance of + or - or example, if a feature has a tolerance of + or - or example, if a feature has a tolerance of + or - or example, if a feature has a tolerance of + or - or example, if a feature has a tolerance of + or -
0.006 inches then the nominal + and n0minal - values are 0.006 0.006 inches then the nominal + and n0minal - values are 0.006 0.006 inches then the nominal + and n0minal - values are 0.006 0.006 inches then the nominal + and n0minal - values are 0.006 0.006 inches then the nominal + and n0minal - values are 0.006
inches.
inches. inches. inches. inches.
CA CA CA CA CAUTION UTION UTION UTION UTION
Enter tolerance values in the appropriate units of measurement. Enter tolerance values in the appropriate units of measurement. Enter tolerance values in the appropriate units of measurement. Enter tolerance values in the appropriate units of measurement. Enter tolerance values in the appropriate units of measurement.
F
FF FFor example, if you are measuring in metric (mm) enter tolerance or example, if you are measuring in metric (mm) enter tolerance or example, if you are measuring in metric (mm) enter tolerance or example, if you are measuring in metric (mm) enter tolerance or example, if you are measuring in metric (mm) enter tolerance
data in metric (mm). data in metric (mm). data in metric (mm). data in metric (mm). data in metric (mm).