HEIDENHAIN IK 5293 - Manual (Page 200)

186
Chapter 5 Advanced Measuring & Output
Offset Alignments
Offset alignments require the nominal location of three points. Use non-pro-
jected (projection plane is indicated as 3d or off ) positonal features.
For example, the nominal center points of three positional features is accept-
able.
To perform an offset alignment (primary plane)
NOTE NOTE NOTE NOTE NOTE
It may be simpler to delete all other features from the features It may be simpler to delete all other features from the features It may be simpler to delete all other features from the features It may be simpler to delete all other features from the features It may be simpler to delete all other features from the features
list before beginning the offeset alignment. This is optional and
list before beginning the offeset alignment. This is optional and list before beginning the offeset alignment. This is optional and list before beginning the offeset alignment. This is optional and list before beginning the offeset alignment. This is optional and
is NOT required.
is NOT required. is NOT required. is NOT required. is NOT required.
Step 1
Click the primary plane button on the datum toolbar.
Step 2
Click on create.
Step 3
Select the offset tab.